MT125A
5922 and 5932 SERIES
INSTALLATION INSTRUCTIONS
THESE INSTRUCTIONS MUST BE
LEFT WITH HOMEOWNER
LEVER HANDLE
TWO-HANDLE LAVATORY
FAUCET
CAUTION:
Always turn water off before disassembling the valve. Open valve handle to alleviate
water pressure to insure that complete water shut-off has been accomplished.
Before turning water on during either rough-in or trim-out, make sure that the cartridge retainer nuts are in place. The
cartridges and cartridge retainer nuts were properly installed and tested before leaving the factory. Although it is
unlikely, it is nevertheless possible that through the handling of the valve by any number of persons the cartridge
retainer nuts may not be properly installed. This should be carefully checked at time of rough-in and trim-out. If the
cartridge retainer nuts are not properly installed, water pressure could force the cartridge out of the casting. Personal
injury or water damage to the premises could result.
®
4" Centers
Cold
Hot
1-7/8"
6-3/4" x 2-3/8" Wide
Mounting
nut/washer
Tailpiece
nut
Supply
(Not Furnished)
15/16" MAX.
SPOUT
Handle insert
(Not supplied)
Handle Screw
Handle Hub
Escutcheon Gasket
FLOW-RATOR
AERATOR
High Arc Spout Model
Tea Kettle Spout Model
➤
➤
➤
➤
➤
➤
➤
➤
➤
➤
➤
➤
➤
➤
➤
➤
➤
➤
Complies with ASME A112.18.1M and CSA B125
