INSTALLING THE WALL CONTROL
CAUTION: To prevent electrical shock, ensure electricity has
been turned off at the circuit breaker before beginning.
NOTE: Fan(s) are required to be installed within 30 feet of
the wall control to ensure reliable communication.
NOTE: Wall control is intended for indoor installation only.
NOTE: You can control your fan with up to 4 wall controls or
remotes (including the pre-paired control).
WALL CONTROL TO WALL OUTLET BOX ELECTRICAL
CONNECTIONS
(
FIG.1
):
1. Connect the green wire marked “GROUND” from the wall
control to the copper wire from the wall outlet box that
feeds back to the circuit breaker – important for proper
fan function.
2. Connect the black wire marked “LINE IN” from the wall
control to the black LINE VOLTAGE wire from the wall
outlet box that feeds back to the circuit breaker.
3. Connect the red wire from the wall control to the black
wire from the wall outlet box that feeds up to the fan.
1
Remember to disconnect the power at the circuit breaker.
1. Carefully tuck the wire connections inside the outlet
box. Secure the wall control with the two (2) wall
control screws provided (
FIG. 2).
2. Attach the wall mounting plate over the wall switch
and secure with the two (2) wall mounting plate
screws provided (
FIG. 2).
3. Fasten the wall plate to the wall mounting plate.
White
White
Red
Black
Green (Ground)
Black (to fan)
Copper
Ground
White
(Neutral)
Black (from breaker)
Wall control
Wall outlet box
4. Connect the white wire from the wall control to the
white (neutral) wire from the wall outlet box.
WALL CONTROL OPERATION
Restore power to ceiling fan and test wall control as below for
proper operation.
PARING THE WALL CONTROL TO YOUR FAN
Your fan is pre-paired at the factory. No pairing is necessary.
NOTE: For pairing instructions please skip to section 3.
WALL CONTROL BUTTON FUNCTIONS
button: Turns the light ON or OFF.
Press or hold to increase the light level.
Press or hold to decrease the light level.
button: Turns the fan ON or OFF.
Press or hold the button to increase fan speed.
Press or hold the button to decrease fan speed.
ON-OFF Switch: Pull tab to power off in
case of emergency. Not necessary for normal
fan operation.
NOTE: Your fan features 6 speeds. An audible tone will indicate
when the speed is increased or decreased. When the fan has
reached the minimum/maximum speed level the audible
indication will stop.
button: Switch between Summer and Winter Mode.
SUMMER MODE (Counter-Clockwise):
A downward airflow creates a cooling
effect (
FIG. 4). This allows you to set
your air conditioner on a warmer
setting without affecting your comfort.
WINTER MODE
(Clockwise):
An upward airflow moves
warm air off the ceiling area and
re-distributes the warm air that hovers
around the ceiling to the living space.
This should allow for savings on
heating costs (
FIG. 5).
NOTE: To operate the reverse button on your fan, press
the button while the fan is running
2
ON-OFF Switch
PAIRING
If you need to re-pair your fan or you want to pair a second
wall control:
1. Power cycle your fan by turning off the power at the
circuit breaker.
2. Press and hold
and
buttons on wall control
for 10-15 seconds.
3. The LED will blink green then remain solid green.
4. The green LED along with audible beeps will indicate
that pairing is successful.
5. Test wall control for functionality.
UNPAIRING
NOTE: Purging must be completed within 3 minutes
of turning the power on to the fan receiver.
1. When you re-engage power to the fans you
want to purge, press and hold the
and
buttons for 4 seconds.
2. The LED will alternate red/green, blink green,
and the receiver will beep to indicate that purging
is successful.
4
3
