Modena EI 3D Series, Руководство пользователя

Страница: 18 / 23

English 15

This is the normal phenomenon. Do not stuck the pressure-release outlet, in case the crack of the
tank cause water leakage.

To avoid overheating, please fill with full water for the water heater firstly before usage.

If power plug damaged, please contact with the professional maintenance service.

When connect the electric circle breaker, the electric water heater should be installed in the fixed
wire route. The distance of all touch points should be 3 mm at least, in order to ensure safety.
INSTALLATION METHOD
Fix water heater

The installation must be done by after-service department or the designated staffs.

This is wall-hang electrical water heater, it must be located at where is:
a. Drainable and unfrozen;
b. Concentrated water use
c. Enough space for maintenance and repair
d. The carry capacity of the installation should not be less than 4 times of completed filled
electrical water heater.
e. No leakage of flammable gas or strongly corrosive gas. No strong electricity magnetic effect.
Avoid direct sunlight, rain, wind and the shock.

Firstly drill 4 holes (please refer to drilling hole picture in the accessory bag) with the drill whose
diameter is smaller than the plug bolt hook. Then use a hammer to knock the plug bolt hooks into
the holes, and then fix the wall-hang board with screw. See the pic.4.

Lift the water heater; move slowly forward until the hook hand the product and lock the screw. Pull
down, left; right once to make sure the heaters is fixed.
Note:

The two plug bolt hooks should be completely in the wall and at the same height horizontally.

For the convenience of the repair and maintenance, leave a space of 50cm at least at the left side
of the water heater(the side of power plug)

Water heater must not be installed transversely and should not incline after installation.
Pipe connection
a. Install the multi-functional valve to the water inlet of the water heater.
b. Construct to the picture of product structure, open the water tap. The inner water pipe should be
clean when installation which avoid blocking the water inlet valve. It is suggested that the water
inlet valve is installed to the water inlet, which is helpful for checking and maintenance.

In the heating process
,
there will be a few water drops come out from the pressure-release hole.
This is a normal phenomenon that shows the system is releasing the pressure to protect the
water heater.