Original instruction notice
11
NOT-MC89-EN-2020-v1
5. Starting up the Portable Valve Actuator
a.
Changing the battery pack
INSERTING / REMOVING THE BATTERY
ATTERY INSERTION AND CABLING
Battery side
LIGHT AND BATTERY CAPACITY INDICATOR
The LED on the lamp (1) is both a light and a battery capacity indicator. Press the LED light switch (2) :
1 x, working area LED illumination
2 x, capacity indicator LED, indicates the charging state of the battery pack:
o
Steady green LED : Charged > 60%
o
Slowly flashing green LED : Charged between 30% and 60%
o
Quickly flashing green LED : Charged < 30%
o
Steady yellow LED : Battery is empty
o
Steady red LED : battery temperature is outside the permitted range.
o
Flashing red LED : indicates a general fault, e.g. incomplete contact, short circuit, battery pack faulty, etc.
b.
Settings
Risk of injury! Only adjust the settings when the power tool is switched off and free of any load.
CHANGING DIRECTION OF ROTATION
Switch to the left = “D1” rotation direction / Right / clockwise
Switch to the right = « D2 » rotation direction / Left / counterclockwise
SETTING TORQUE LIMIT AND SPEED
The torque and speed adjustment knobs provide different rotational speeds and torque limits. The matrix below shows the
values for each combination and for each direction of rotation. Once the desired torque limit is reached, the actuator
sounds a beep and stops. It restarts only after releasing and pressing the power switch again
This sound signal may also indicate that the starting torque required is too high (in that case, the actuator will not start and
a beep will sound), or that the actuator is overloaded.
1
2
