6
o
Accessories mounted or activated by the actuator are in good condition and correctly
attached.
o
The most suitable torque retention system is being used and it assures the safety of
the operator.
o
The system that fixes to the valve is adapted to the valve.
o
Both the actuator and the operator are in a stable position. The operator is placed in
opposition to any possible movements the actuator may make while coming to a
stop.
•
Stop the actuator immediately if it starts to behave differently (a change of noise,
increased vibrations). Replace all damaged parts of the actuator and accessories. Damaged
parts can burst and cause serious harm, even a potential fatality.
•
Before placing a valve on, or removing it from, the actuator, wait until the actuator has
come to a complete stop.
•
Only activate the command to inverse the direction left/right when the actuator is fully
stopped, otherwise the operator may find they are working in a poorly adapted position.
•
Always hold down the rotation direction switch until it stops.
In certain circumstances, the tool may keep rotating for several seconds after
releasing the switch. Never put your hands close to the tool or any moving parts.
•
Keep the ventilation slits on the actuator and the batteries free and clean to ensure
adequate cooling.
•
Keep the contacts on the machine, charger and battery pack clean.
•
Don’t open the battery. Risk of short-circuiting.
•
Protect the battery from heat, for example direct exposure to the sun, to
fire, to water and to humidity. There is a risk of explosion.
•
In case of damage or non-conforming use of the battery, vapors could
escape. Ventilate the work place and consult a doctor if you feel unwell.
Transporting the actuator
•
Keep the original casing for return in case of any revisions or repairs.
•
When packing, make sure that all switches are off and without any constraints.
•
Always pack the tools in the correct spaces to avoid them knocking against each other.
•
Replace the batteries in their allotted casing.
•
Lithium-ion batteries are subject to rules regulating the transport of dangerous materials. The
operator can transport the batteries by road without taking any additional measures.
•
When transporting via a third party (for example, by air or a via a transport company), you
must conform to the specific measures regarding packaging and labelling. In such a case, it
is imperative to take advice from an expert in the transport of dangerous materials when
preparing the transportation. Only send the batteries if the packaging is not damaged. Protect
the battery connectors and pack the batteries tightly so they cannot move. Please also follow
any additional regulations that may apply.
Storing the actuator
modec
actuators must be stored in a dry and correctly ventilated environment to ensure there
is no corrosion of the internal mechanic parts.
Protecting the environment
To eliminate waste, conform to the stated national requirements. The actuators and their
accessories must not be thrown in a waste bin. Make sure you dispose of the tools in specialist
recycling centers.
