20
Torque reaction arm BR001
MOUNTING THE BR001 TORQUE REACTION ARM AND THE ANCHOR STRAP
Pull on each pull-tab with the ring and make a quarter turn so that they remain in the pulled position. Place the
black ring of the torque reaction arm on the flange so that the 6 pins fit into the corresponding holes.
Make another quarter turn with the rings of the pull-tab and release them, making sure that they are inside.
Check that the torque reaction arm is correctly attached to the flange.
ROTATION ADJUSTMENT D1 AND D2
See page 14
Telescopic valve key EB002 and the extension bar EB012
The EB002 telescopic valve key and its fixed extension EB012 allow the operation of underground
valves. It has a 3/4" square at one end to accept a standard socket and a female spline at the other
end to accept the actuator output shaft. Its length is adjustable from 0.6m to 0.9m in 8cm
increments. The length of the fixed extension EB012 is 0.5m. This gives a total (EB002 + EB012) of
1.4m. Maximum allowable torque: 1000 Nm
MOUNTING THE PORTABLE ACTUATOR ON A MODEC TELESCOPIC VALVE KEY
2
1
