B
A
C
D
E
F
G
SER
VICE
50
The location of this cradle should be decided by taking into account the following factors:
□
Simple and convenient access for the user
□
Away from air flow and drafts through the room
□
The parts of the room that people are likely to spend time
□
Away from direct sun light
□
A suitable distance away from the heater
□
Ideally 1.2m to 1.5m from the floor
The radio frequency signal will go through some walls but for best
results Escea suggest that the cradle position is less than 10 metres
away from the heater.
The best height off the ground to locate the cradle is about chest
height. This gives a good average room temperature and easy access for the user.
Please ensure that the cradle is screwed firmly onto the wall using the screws provided.
F9 Operating the Appliance
If you haven’t done so already, insert the supplied “AA” size batteries, being careful of the polarity.
“0:00” should now be showing on the remote display.
To turn the fire on, press the ‘POWER’ button once; within a few seconds the appliance will begin its
startup sequence.
NOTE: The appliance begins its startup with a 15 second pre-start purge, where the combustion fan runs on
its own to clear the firebox before it tries to ignite. During the pre-purge the remote will alternately show the
remotes “set” temperature and a rotating segment indicator to show that the fire is in start up mode and will
try to ignite.
When the appliance has lit, set the room temperature by pressing the ‘PLUS’ or ‘MINUS’ buttons
repeatedly until the display is showing the desired temperature. The remote will then revert back to
the ‘current’ room temperature 30 seconds after making the change.
Run the appliance on full for an hour with the windows and doors open in the dwelling. This will ensure
any initial smells have the chance to dissipate.
The appliance is turned off by pressing the ‘POWER’ button once more. The remote will display the
time only.
Run the appliance again and check the operation of the thermostat by increasing and decreasing the
set temperature. Check that the Effect Only and Fan Boost functions work correctly.
For further operation instructions please refer to the User Guide.
