Mocon AMETEK Dansensor Lippke 5000, Руководство пользователя

Страница: 39 / 136

Dansensor
®
Lippke
®
5000 EN User Guide 37
P/N 380419-C
05/2022
2. Tests
Test types
Standard tests
The following standard tests can be performed:

Burst Test/Seal Strength (ASTM F2054) – see page 39

Leak Test/Pressure Loss (ASTM F2095) – see page 43
NOTE! If you want to upgrade your device with one or more of the test options
below, please contact your service provider.
Creep tests
When the Creep Test option has been purchased, a Creep test or a Creep2Fail test can be
performed according to ASTM F1140. The creep test evaluates the strength of the seal on a
package.

Creep test – see page 45

Creep2Fail test – see page 48
Combined testing
(Only available with the PC Software)
When the Combined Tests option has been purchased (requires the Creep Test option), the
Creep , Leak and Burst tests can be combined in various ways and performed as a single test.
The results of each individual test will be reported at the end of the test sequence. Combined
testing can simplify operator setup and reduce the number test samples required.
The following combined tests can be performed:

Combined Leak/Creep

Combined Leak/Burst

Combined Creep/Burst

Combined Leak/Creep/Burst
Bubble test
When the Bubble Test option has been purchased a bubble test can be performed according
to ASTM 2096.

The test can be used to see where a leak is placed or to check the barrier of for example a
Tyvek package - see
page 51 for details.