Mobotix D25M, Руководство пользователя

Страница: 92 / 140

92
/140
D25M Camera Manual: Installation
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
www.mobotix.com • sales@mobotix.com
• Remove the camera dome : Take the delivered plastic foil
or a cotton cloth, insert the dome into its seat and turn it in
clockwise direction.
• Attach the outer shell : Place the outer shell onto the camera
and tighten all four Allen screws using the supplied Allen
wrench. Make sure that the rubber seal is seated properly.
2.9.7 Connecting a Two-Wire MxBus Cable
You can use such a cable to connect additional MOBOTIX
modules (e.g., the MX-GPS-Box or the MX-232-IO-Box)
to the D25M.
Note that you can attach one MxBus cable (with two wires)
to the MxBus connector (red arrow in figure). Take care
not to switch the polarity of the wires. It is recommended
to use the same wire color for +/– for the entire MxBus system (e.g., red = +, blue = –).
Procedure
•
Uninstall camera
: Remove the camera so you can access
the connectors on the back.
• Remove the outer shell : Remove all four Allen screws using
the supplied Allen wrench. Take off the outer shell.
•
Remove the camera dome
. Take the delivered plastic foil or
a cotton cloth and remove the dome by turning it in counter-
clockwise direction.
In order to attach MxBus
modules, you need to
use the supplied MxBus
connector with two-wire
connection line and two
single-wire connectors:
The length of the entire
MxBus wiring must not
exceed 50 m/55 yd!