Mobotix D25M, Руководство пользователя

Страница: 62 / 140

62
/140
D25M Camera Manual: Installation
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
www.mobotix.com • sales@mobotix.com
2.3 Mounting The Camera With The On-Wall Set
2.3.1 Mounting Instructions
On-Wall Sets available in 0° and 10° inclinations allow the D25M to be installed quickly
and easily on the wall or ceiling of a room. When using the set outdoors (IP65), ensure
that the screw holes on the rear of the camera housing are sealed with the included foam
rubber washers. It is not possible to install the On-Wall Set directly above a surface- or
flush-mounted socket.
The 10° On-Wall Set is the right choice if you want to mount the D25M on a wall with the
lens pointing vertically downward (90° or more). If the 10° On-Wall Set is not used, then
the angle of the lens may not exceed 80° for design-related reasons.
If the discreet appearance of the D25M is of particular importance, the In-Ceiling Set is
ideal for mounting the camera on ceilings or drywalls.
The network connection and drill holes must be prepared correctly before installing the
On-Wall Set (both indoors and outdoors):
• Network connection : You can use any one of the four openings in the On-Wall Set
to guide the cabling into the camera. The network cable must be fed through the
opening without a connector. An additional connector to connect to the camera
cable is required.
• Preparing the drill holes : Use the supplied drilling template for the D25M On-Wall
Set (fold-out at the end of this manual) to mark the exact position for drilling the
anchor holes with regard to the camera position.
Caution
When using the On-Wall Set outdoors, ensure that the screw holes on the rear of the
camera housing are sealed with the foam rubber washers included in delivery (IP65).