Mobeye CMVXI-R, Руководство пользователя

Страница: 19 / 28

18
7. PROGRAMMING WHEN USING OWN SIM CARD
Using your own SIM card programming proceeds via SMS commands. The GSM
module requires network connection during programming. If the Mobeye Outdoor
Detector runs entirely on batteries, it must first be put into programming mode.
7.1 PROGRAM MODE
The program mode can be achieved by holding the tag to the tag reader for 5
seconds, until a second beep sounds. The LED in the tag reader starts flashing red
and green. Alternatively, the program mode can be accessed by (re) inserting the
batteries.
First the GSM module establishes network connection. During this time the LED in
the tag reader flashes green/red. Normally this takes 10-30 seconds. Next it will
shortly flash very fast. Once the connection is established the status LED starts
flashing 1 sec. on/1 sec. off (or stays on continuously in case the first telephone
number has been configured).
In program mode, the device is ready to receive SMS commands. If no correct
command is received for 3 minutes, the GSM module switches off in order to save
the batteries. The unit returns to the low power operational mode.
The program mode is interrupted by keeping the tag against the tag reader for one
second.
7.2 PROGRAM AT LEAST ONE TELEPHONE NUMBER
The Mobeye Outdoor Detector is able to send messages up to 5 telephone
numbers. The first telephone number (TEL1) belongs to the administrator. Technical
messages (such as
battery low ) are sent to the administrator only. Without the
administrator
’s phone number, the Mobeye Outdoor Detector cannot function.
When the Outdoor Detector is in initial (factory) status and the batteries are inserted
(so the LED is flashing), the administrator
’s number is programmed by calling the
telephone number of the Mobeye Outdoor Detector using the administrator
’s phone.