Mobatime MOBALine SAM 100, Монтаж и инструкция по эксплуатации

Страница: 11 / 20

© MOBATIME 11 / 20 801073.10
4. Display and control elements
The display and control possibilities of the movement depend on the device version. It can be
determined from the article number printed onto the sticker on the rear side of the device (e.g.
A/N: 118171.01 or 118171.02 ). Differences between the versions are noted.
4.1 LED
Version Condition Signal (duration: 2 seconds)
00/01 02
 
Normal operation

12:00 mode

Minute mode

Second mode

ID mode

Factory settings
 
No power supply
 
No synchronization*
 
Power supply error
 
Detection error second hand
 
Detection error minute hand
 
Internal error**
 
Test mode active
* Is also shown during establishment of the synchronization. With DCF, this process
takes several minutes, with MOBALine approx. 5 seconds. A weak connection can
cause the dial-up to take longer.
** Movement must be replaced.
The various menus are detailed below.
4.2 Push-button functions
V00/01
Push Action
<1s
Change to next second mode
(double-click: change to previous mode)
>4s Switch between normal operation and 12:00 position
>15s Movement is reset to factory settings
V02
Push Normal operation Menu
<1s
- In minute or second mode menu:
Change to next minute/second mode
(double-click: change to previous mode)
1s - Change to next menu:
12:00 position

Minute mode

Second mode
3s Switch to
12:00 position Switch to normal operation
>15s Movement is reset to factory settings