© MOBATIME
25 / 108
801104.05
6.5.3
DCF / Pulse / Frequency output
DTS 4132.timeserver Moser-Baer AG
====================================
DCF / PULSE / FREQUENCY OUTPUT 1
1 Mode (0=off, 1=DCF, 2=pulse, 3=frequency) 0
2 Time zone [0] UTC
3 Pulse type (0=sec 1=min 2=hour 3=user) 0
4 Pulse length 100ms
5 User defined pulse type 1sec
6 Correction of output 0ms
7 Frequency 1000Hz
98 Return and save
99 Return and discard changes
Enter desired menu number>
Path: 2 Configuration
1 Outputs
2 DCF / pulse / frequency out 1
1. Select line function: Line switched off, line DCF output, line pulse output, line
frequency output
2. Select time zone
see chapter 6.5.28 Time zone selection.
3. Select pulse mode: every second, minute, hour or user-defined.
(Only active with the pulse output function)
4. Select pulse length in ms (1-500ms)
(Only active with the pulse output function)
5. User-defined pulse interval (1-3600 sec) only active with pulse type 3 (=user) (the
value is also only then displayed). The pulse always occurs after a multiple of the
pulse interval from the 0 second in the 0 minute, e.g.:
– Pulse interval 960 sec. (16 min.)
Pulse occurs: 00:00:00, 00:16:00, 00:32:00, 00:48:00, 01:00:00, 01:16:00 ...
– Pulse interval 25sec
Pulse occurs: 00:00:00, 00:00:25, 00:00:50, 00:01:15, 00:01:40, 00:02:05 ...
... 00:59:35, 01:00:00, 01:00:25 ...
6. Output correction (-500ms...+500ms)
7. Frequency (1 Hz … 5 MHz)
Important:
Only frequencies which fulfill the following requirements are to be used,
otherwise, phase shifts occur:
20'000'000 / frequency = whole number value
Important:
Frequencies above 2 MHz are not sent out as a square-wave signal
anymore.
