Mobatime DTS 4020.timebridge, Монтаж и инструкция по эксплуатации

Страница: 8 / 94

© MOBATIME 8 / 94 801299.00
3 General Information: Introduction
3.1 Scope of Delivery
Please check your delivery for completeness and notify your supplier within 14 days
upon receipt of the shipment if it is incomplete.
The package you received contains:
•
DTS 4020.timebridge
•
Connector set
- 1-2
1)
piece(s) plug 3-pole black for power supply
- 1 piece spring terminal 2-pole orange
•
1 piece mounting tools with spring terminals
1)
Depending on power supply option, see chapter 10 Redundant Power supply
3.2 Technical Data
See Appendix "H Technical data“.
3.3 Device Description in this Manual
This instruction manual is for the DTS 4020.timebridge .
3.4 Introduction
The DTS 4020.timebridge serves as an interface between the IEEE1588 protocol
(PTP) supplied across a packet network to traditional serial Time-of-day (ToD), 1PPS,
10MHz and IRIG B signals.
It is a PTP Slave according to IEEE 1588-2008 for the synchronization.
It is equipped with up to 2 network ports (IPv4/IPv6). LAN1 is for configuration, LAN2
for synchronization and time distribution.
NTP clients can use the DTS 4020 as a reference. NTP is available on both LAN ports
and unicast or multicast is supported.
In addition, the DTS 4020 provides one output for Time-of-Day, two configurable digital
frequency outputs and one analogue 10MHz output.
Instead of a frequency, IRIG/AFNOR is available on the analogue and digital outputs.
For alerting the DTS 4020 can send both e-mails and SNMP traps. It has also an alarm
relay contact.
Using MOBA-NMS and SNMP, the DTS 4020 can be fully operated and its
configuration and system status can be requested.