Mobatime DSC. 250.4, Инструкция по эксплуатации

Страница: 133 / 144

TZI series
133
BE-801372.01-Digital_clocks_manual-221114
©MOBATIME
7.11.4 Mounting
7.11.4.1 Single sided
• The frame is fixed using suspensions (above) and sliding springs (bottom). Lift‑off the anchoring
plate using a screwdriver inserted in between the sheet and the frame at the sliding spring point
on the clock bottom side.
• Drill anchoring holes into the wall of a diameter adequate to accommodate wood‑type screws
of 4 to 5 mm diameter. As a template for marking the position of the holes, the anchoring plate
can be used.
• Interlace the incoming conductors through the opening in the anchoring plate and fix the plate
to the wall.
• Connect the incoming conductors in accordance with the descriptive sheet on the terminal board,
placed on the anchoring plate. Give the conductors an appropriate shape or cut them off to a length
that will not obstruct the placement of the clock frame onto the anchoring plate.
• For NTP variant mount the connector to the Ethernet cable and plug it into the Ethernet socket
mounted on the anchoring plate.
• Put the clock frame opposite to the anchoring plate and suspend it onto the upper springs. Snap
the clock in onto the springs by pushing on the lower part of the frame. Take care to not nip any
of the cables between the anchoring plate and clock frame.
• Check whether the anchoring plate on the sides fits exactly into the groove in the clock frame.
• Remove the blind cap from the openings on the clock bottom side.
•
Insert Allen key into the openings on the bottom side of the clock. Turn the key softly in anticlockwise
direction. The frame catch will snap in.
• Replace the blind cap on the openings.
•
To loosen the frame catch, use the reverse procedure (turn clockwise).