Mobatime DSC. 250.4, Инструкция по эксплуатации

Страница: 119 / 144

DSC series
119
BE-801372.01-Digital_clocks_manual-221114
©MOBATIME
7.9.4 Mounting
7.9.4.1 Single sided DSC.100–DE.320
• Assemble the wall mounting console if delivered disassembled.
• Drill at least four anchoring holes into the wall of a diameter adequate to appropriate screws,
use the mounting console as a template.
• Mount the console on the wall and put it into a fully tilted out position.
• Shift the clock body into the flipped out console arms and fix it by tightening the screws.
• Dismantle the back cover of connectors on the clock body. The cover incorporates gap with sealing
for passage of cables in the inside of the clock.
• Arrange all cables to appropriate length and connect them to the appropriate terminals on the PCB.
See the description of the connectors.
ď
Observe the correct polarity where necessary.
• Fix the cables with the holder in correct positions in order to maintain regular spacing between
the cables in the area of passing through sealing. Use appropriate force to not to damage the cables
insulation.
• Configure the position of DIP switch according to used synchronization signal (applies only for DCF,
MOBALine, polarized impulse line or IRIG‑B)
• Mount back the connector cover.
• Tilt the clock into vertical position and fix the position of the console.
7.9.4.2 Single sided DSC.500
• Drill at least four anchoring holes into the wall of a diameter adequate to appropriate screws,
as a template for marking the position of the holes use the wall bracket.
• Mount the console to the wall using appropriate screws and dowels with respect
to the material.
• Loosen the hanging M10 Allen screws on console in order to be approx. 6 mm of thread
visible.
• Prepare the cables and fix them on the wall in order to be placed behind the small rectangular cover
equipped with sealed slot.
• Hang the display body onto the console in order to fit four hanging screws into the pear‑shaped
holes.
• Using special key unlock (turn by 90° clockwise) the two locks on the bottom of the frame and open
the front window. Use the support to keep the front window opened.
• Tighten four hanging screws using the Allen key, the display is then fixed on the wall.
• Dismount the small rectangular cover on the bottom part of back panel, pull all cables through
the opening and fix them by the metal bar. Mount the cover back. Make sure the cables are evenly
distributed in the fixing bar and in the sealed slot.
• Arrange and cut the cables to the appropriate length. Strip the wires and connect them
to corresponding board terminals.
ď
Observe the right polarity where necessary.