MOBA Farmpacker M100T, Руководство по обучению

Страница: 26 / 59

-
Release 5
26 Training manual , MOBA Farmpacker M100T
The mode is set on the controller connection 7 and 9 (Open = FOR).
NOTE
a
The MOBA Farmpacker M100T is set in the FOR-mode
5.2.1 LUST Indication LED’s
On the LUST controller you find 3 Indication LEDS. H1, H2 and H3. They indicate a status or error
messages
Table Status indications.
In case of an Error the Red LED H1 start a flash sequence.every 20 seconds he repeats this sequence
• Main power on - All LEDS Off
• Press “Key switch” - H3 = On
• Press “I/O’ - H2 Blinks / H3 = On
• See table for status indications
Tab. 2 - Status LED indications
Device status Red H1 Yellow H2 Green H3
Power On - - On
Ready (ENPO-Set) Off On On
In service/Auto-tuning
active
Off Blink On
Warning On On/Blink On
Error Blink (Flash code) Off On
Tab. 3 - Error flashing code LED H1
Flashes per
20 sec.
Display KeyPad
Optional Explanation Cause/Remedy
1x E-CPU Collective error MSW1
Power-off, remove all control signals, power on. If error
reoccur, inform Moba Service.
2x E-OFF Under voltage shut-off
Check power supply. Also occurs briefly in response to
normal power-off
3x E-OC Current Overload shut-off
Short-circuit, ground fault: Check cabling of
connections, check motor coil, check neutral conductor
and grounding.
Device not setup correct. Check parameters of control
loops. check Ramp settings.
4x E-OV Voltage Overload shut-off
Voltage overload from mains: Check mains voltage.
Restart device.
Voltage overload resulting from feedback from motor.
Slow down braking ramps, if not possible, use a
braking resistor.