GENERAL
WARNING
Care should be taken when installing into high ‘clay’ content soils which naturally retain water and have poor
drainage.
This product is not suitable for installation in or near a coastal or marine environment.
Clean the external surfaces with a damp cloth using a mild solution of detergent and warm water only, do not
use aggressive cleaning products or solvents which may damage the product.
Do not use any source of high-pressure washers to maintain or clean this luminaire.
A light film of acid-free oil is recommended after installation and maintained periodically (2-3 times a year) to
aid corrosion prevention.
This product is dimmable dependent on lamp type.
This product should be recycled in the correct manner when it reaches the end of its life. Check local authorities
for where facilities exist.
• Remove the lamp retaining clip inside the top of the fitting, insert a suitable GU10 lamp (not included) into
the lampholder, and secure with the lamp retaining clip
• Replace the glass, gasket, and bezel ensuring the seal is in place and not damaged, and refasten the hex
screws
• Switch on and check for correct operation
• Should the protective glass be cracked or damaged it should be replaced immediately
• This fitting must not be used without the protective glass installed
