MKS MKSINST IE1000A, Инструкция по эксплуатации

Страница: 53 / 75

Chapter Five: Diagnostic Interface Setup, Configuration,
and Operation Step 3: Connect to the IE1000A High Flow Rate Mass Flow
Controller
45
9. Hit the <Tab> key on the left hand side of the keyboard and a subnet mask is automatically entered.
10. Click OK to close the window.
11. Close the remaining network connection windows
The host computer is ready for communication with the IE500A / IE1000A High Flow Rate Mass Flow
Controller.
Step 3: Connect to the IE1000A High Flow Rate Mass Flow Controller
Before trying to connect to the IE1000A High Flow Rate Mass Flow Controller, the communications network
must be set up correctly. Complete the steps listed above if you have not already done so.
1. Launch an HTML browser.
2. Enter “http://192.168.2.155” in the address field.
3.
Click “Go”.
Internet Explorer will open and display the Device page in Monitor Mode. This page will show the model
number and serial number of the IE500A / IE1000A High Flow Rate Mass Flow Controller. The serial
number can always be found in the bottom left-hand corner of the browser window.
The modes are described in detail below.