MKS MKS TFT28, Руководство пользователя

Страница: 16 / 45

7 Breakpoints recovery
When you spend most of your time printing a model, the careless error operation causes the print to
stop, but does not want to waste the printed model. Then you can use the breakpoint to continue to play the
function, save your beloved model. The following illustration requires that you follow these steps:
1. First click
“
Preheat
”
, the extrusion head and hot bed target temperature set (no hot bed can ignore the
hot bed target temperature).as Figure 1
2. When the temperature reaches the target temperature, click
“
homing
”
, choose to homing, so that the
axes are back to home point. (Attention:Model printing failure to select Breakpoints recovery the
operation between the Midway, if there is a power outage must be homing operation, such as
continuous electricity can not return to home point operation) .as Figure 2
3. After the axis back to home points, move the z axis will touch the mouth to stop printing of the layer,
such as Figure 3, Figure 4, the time to test eyesight (can be selected in the configuration file to allow error,
the following figure
4. Point setting, click on the breakpoint recovery and select the file to be printed on the breakpoint
recovery, as shown in Figure 5, figure 6.
5. After you select the file, wait for it to print.as Figure 7.
(After selecting the model, the larger the model, the more complex it is, the longer it waits here.)
The steps of breakpoints recovery: