23 | ESP302-GPIB-ADPT
A1387A0-EDH0429En1010 11/21
USER's MANUAL
4.3 Important note to former ESP301 controller users
Users who would like to replace their former ESP301 controller GPIB driven application by an ESP302
+ ESP302-GPIB-ADPT must be aware of the following:
•
As mentioned above, messages sent to the ESP302 must terminate by LF (and/or EOI
asserted) instead of CR.
•
As mentioned above, ESP302 messages terminate by CR+CR+LF instead of CR+LF.
•
ESP301 "SA" command should be replaced by the previously described procedure to set
the GPIB address. Basically, the GPIB address is set in the ESP302-GPIB-ADPT and not
in the ESP302.
•
ESP301 "RQ" command is accepted by the ESP302 but has no effect since no service
request can be processed through the serial line.
