946 Controller Instruction Manual
pg. 30
6.5 Channel Setup for Pressure Measurement
6.5.1 Overview of 946 Channel Setup
Front panel setting of the parameters associated with devices connected to the 946 Controller such as
calibration, gas selection, relay set point, control set point, and control channel selection are
accomplished using Channel Setup.
Figure 6-7 shows the channel setup parameters for all of the sensors and devices operated by the 946
controller. The default values are shown in the brown boxes while the ranges for setup are shown in the
blue boxes. The 946 automatically shows the parameters available for the sensor in operation on the
channel selected.
To perform a Channel Setup:
•
Select the desired channel by pressing either
or
on the front panel until the green LED on
the left side of the display is aligned with the desired channel.
•
Once the channel (sensor) is selected, the setup panel is displayed by pressing
Channel
Setup
. The
keys are used to select the parameter to be changed.
•
Press
Enter
to highlight the parameter value, then press either
or
to change the parameter
value.
•
Press
Enter
to save the new value.