MK Martin Meteor 54, Руководство оператора

Страница: 11 / 40

11
Meteor Snowblower
Hand Crank Assembly Information
Upon receiving the Meteor Blower
The blowers are shipped in a packaged state
Carefully remove the chute and PTO shaft from the area of the auger and set them aside. Lo-
cate the bag or package of small components.
Remove the ties that hold the plastic ring on the blower, apply a light coat of grease to both
sides of ring and replace. Place the base of the chute on top of the plastic ring, the base of the
chute will now slide under the clamp with the 3 hold-down bolts.
Place a 1/2" SAE washer and a bearing on the 2 holes of the chute support, place a thin wave
washer on top of the bearing, place the 2 hole clamp on the washers and bearing with the off-set
facing up and out. Secure with 1/2-20 x 2 bolts. The thin wave washer is to ensure the bearing
race does not drag on the clamp.
Install the hand crank.
First remove the 2 nuts as shown, and insert the crank tail bracket and reinstall the nuts. Bolt
upper bracket to top "A" Frame brace. Test crank to make sure it rotates freely.
Item # Part # Description Qty
1 31141 Tail Bracket 1
2 34969 Retainer Pin 1
3 31144 Crank Worm 1
4 OL Bolt 1/4 x 1 1/2 c/w 2-Way locknut 1
5 OL Bolt 5/16 x 3/4 Sq Set Screw 2
6 31142 Crank 1
7 31140 Upper Bracket 1
8 OL Bolt 3/8 x 1 1/4 c/w lw,n 2
Hand Crank Parts list