25
4
Operation
4.6 Trendelenburg
WARNING
When you operate the Trendelenburg operation, make sure to use the fixture for the
accessory of the Mizuho operating table. The patient may fall from the operating table.
CAUTION
•
When performing the head down operation, be careful that the head plate tip does
not contact the floor. It may get damaged.
• When performing the head down operation, be careful that the head plate fixing
handle does not contact the cover. It may get damaged.
Reverse Trendelenburg (Head up)
1.
Hold down
ENERGIZE
and press
REV. TREND.
.
The tabletop moves to the head up position.
TABLE UP
ENERGIZE
ON/OFF
ＰＲＥＳＳ ＴＯ
ＬＯＣＫ ＢＲＡＫＥＳ
LEVEL
BRAKE UNLOCK
REFLEX
FLEX
SLIDE HEAD
SLIDE FOOT
TABLE DOWN
BACK UP
BACK DOWN
TILT LEFT
TILT RIGHT
REV. TREND.
POWER BATT.
PILOT
MOT-5602BW
TREND.
Head up position
Trendelenburg (Head down)
1.
Hold down
ENERGIZE
and press
TREND.
.
The tabletop moves to the head down position.
TABLE UP
ENERGIZE
ON/OFF
ＰＲＥＳＳ ＴＯ
ＬＯＣＫ ＢＲＡＫＥＳ
LEVEL
BRAKE UNLOCK
REFLEX
FLEX
SLIDE HEAD
SLIDE FOOT
TABLE DOWN
BACK UP
BACK DOWN
TILT LEFT
TILT RIGHT
REV. TREND.
POWER BATT.
PILOT
MOT-5602BW
TREND.
Head down position
NOTE
•
The maximum angle of
head up or head down is
25 degrees from the level
position.
25°
25°
25°
25°
•
If the slide cylinder is tilted
close to the column base,
the slide cylinder will stop
for prevention of getting
damaged and the buzzer
will sound. Once the buzzer
sounds, the slide cylinder
cannot be tilted any more.
Slide cylinder
•
When Trendelenburg is
operated in the opposite
direction from the current
Trendelenburg position,
it will stop in the level
position. Once it stops,
release the switch and
press it once again; the
tabletop will be tilted to the
maximum angle.