Mitsubishi QJ71GP21-SX, Справочное руководство

Страница: 355 / 650

9
DEDICATED INSTRUCTIONS
9.7 J(P)/G(P).REQ (Remote RUN/STOP)
9
- 53
9
DE
DICA
T
E
D
INS
T
RUCT
IONS
10
T
R
OUB
L
E
S
HO
OT
IN
G
APPENDI
CES
INDEX
9.7 J(P)/G(P).REQ (Remote RUN/STOP)
This instruction is used to remotely run or stop a programmable controller on another
station.
(1) Setting data
* 1 The local devices and file registers for each program cannot be used as devices in setting data.
Table 9.24 Devices available for setting data
Setting
data
Available devices
Internal device
(System, User)
File
register
Link direct device
J \
Intelligent
function module
device
U \G
Index
register Zn
Constant
Others
Bit Word Bit Word K,H $
(S1) — —
(S2) — —
(D1) — —
(D2) —
Figure 9.50 Instruction format
Table 9.25 Setting data
Setting data
*1 Description Data type
Jn
Network number of the own station (1 to 239, 254)
254: The network specified in Valid module during other station access
Binary 16 bits
Un
Start I/O signal of the own station's CC-Link IE controller network module
(00 to FE
H
: The higher two digits of the 3-digit I/O number)
(S1)
Start device of the own station that will store the control data
( (2) Control data, request data, and response data in this section)
Device name (S2)
Start device of the own station that stores request data
( (2) Control data, request data, and response data in this section)
(D1)
Start device of the own station that will store response data
( (2) Control data, request data, and response data in this section)
(D2)
The own station's device that is turned on for one scan upon completion of the
instruction
(D2)+1 also turns ON if the instruction execution has failed.
Bit
J.REQ
Start contact
[Instruction format] [Execution condition] [Instruction symbol]
JP.REQ
Start contact
J.REQ
Jn (S1) (S2) (D1) (D2)
JP.REQ
Jn (S1) (S2) (D1) (D2)
G.REQ
Start contact
GP.REQ
Start contact
G.REQ
Un (S1) (S2) (D1) (D2)
GP.REQ
Un (S1) (S2) (D1) (D2)