5
4. HANDLING INSTRUCTIONS
(1) Do not use solid wires with this connector.
(2) Do not drop the connector case and wiring tool or give them high
impact since they are made of resin.
(3) Do not disassemble the connector case.
It may cause a failure.
(4) Tighten the fixing screws and cover fixing screws within the
following ranges.
(5) When the Q6TA32 is installed to the I/O module, it is 9 mm (0.35
inch) out of the I/O module bottom. (Refer to "6. OUTLINE
DRAWING".)
Pay attention to the installation position.
(6) The Q6TA32 cannot be used with any model that is not mentioned
as the applicable model in the performance specifications.
Screw
Tightening Torque Range
Insulation displacement connector fixing screw (M2.6 screw)
0.21 to 0.28 N • m
Cover fixing screw (M2.6 screw)
0.21 to 0.28 N • m