Mitsubishi MELSEC-F FX2N-1RM-E-SET, Руководство пользователя

Страница: 76 / 140

BFM Assignment 7
7-12
FX
2N
-1RM-E-SET Programmable Cam Switch
7.4 Program example
7.4.1 Program example which uses FROM/TO instruction
A program example using FROM/TO instructions is shown below.
In this program, data is output to the PLC main unit, each data is read, and commands are
written. (Each data and each status are read only.)
In the program example above, the FX
2N
-1RM is changed over to the RUN mode by input to
X000 of the PLC main unit, and the FX
2N
-1RM is changed over to the PRG mode by input to
X001.
M8000
FROM K0 K10 K4Y0 K3
Outputs the ON/OFF information of BFM #10
to BFM #12 (Y0 to Y57) to Y0 to Y57 of the
programmable controller.
FROM K0 K8 D0 K2
Reads BFM #8 (current angle) to D0, and
reads BFM #9 (rotation speed) to D1.
FROM
K0 K28 K2M0 K1
Reads BFM #28 (status) to M0 to M7.
TO K0 K3 K2M10 K1
Writes the command M10 to M17 to BFM #3.
X000
M10
RUN command
X001
M11
PRG command
X2
M13
Error reset