Mitsubishi L26CPU-BT, Руководство пользователя

Страница: 392 / 450

App - 28 App - 28
APPENDIXES
Appendix 3.2 Link special registers (SW)
Data is stored in the link special registers SW000 to SW001F by the program, and data
is automatically stored in SW0020 to SW01FF. The values in parentheses in the
number column indicate the buffer memory addresses.
When the standby master station is controlling the data link, availability is basically
identical to that of the master station.
When the standby master station is operating as a local station, availability is identical
to that of a local station.
POINT
Do not write data to the area of the No. which does not exist in the link special
register (SW) list.
Writing data to the area of the No. which does not exist in the list may cause
malfunction of the programmable controller system.
The following table lists the link special registers.
Availability
( : Available, : Not available)
Online
Number Name Description
Master station Local station
Offline
SW0003
(603
H
)
Multiple temporary
error invalid station
specification
Select whether multiple temporary error invalid stations are
specified.
00 : Specifies multiple stations indicated by SW0004 to
SW0007.
01 to 64: Specifies a single station from 1 to 64.
(The specified number indicates the station number of a
temporary error invalid station.)
SW0004
(604
H
)
SW0005
(605
H
)
SW0006
(606
H
)
SW0007
(607
H
)
Temporary error
invalid station
specification 2
Specifies a temporary error invalid station.
0: Not specified as a temporary error invalid station
1: Specified as a temporary error invalid station
16 15 14 13 4 3 2 1
48 47 46 45 36 35 34 33
32 31 30 29 20 19 18 17
64 63 62 61 52 51 50 49
b15 b14 b13 b12
to
b3 b2 b1 b0
SW0004
SW0005
SW0006
SW0007
Numbers 1 to 64 in the above table indicate the station numbers.
to
to
to
to
Error invalid stations, reserved stations and any station of the
number higher than the max. are not specified
.
SW0008
(608
H
)
Loop test station
setting
0 : Entire system (executed for all stations)
01 to 64 : Specified station only
Default value: 0
SW0009
(609
H
)
Monitoring time
setting
Sets the monitoring time when a dedicated instruction is used.
Default value: 10 (seconds)
Setting range: 0 to 360 (seconds)
The monitoring time of 360 seconds will be used if a value
outside of the above setting range is specified.
If a value is set in SW000B, time elapsed until error completion of a
dedicated instruction is as follows:
(Number of r 1) x Monitoring time
2: Only the bit for the first station number is turned on.
(To the next page)