Mitsubishi GOT2000Series, Руководство по подключению

Страница: 134 / 338

6 - 14
6. CONNECTION TO YASKAWA PLC
6.2 Serial Connection
POINT POINT POINT
(1) Delay Time
When connecting to PLC CP-9200(H) and CP-
9300MS, set the following.
(2) Communication interface setting by the Utility
The communication interface setting can be
changed on the Utility's [Communication setting]
after writing [Communication Settings] of project
data.
For details on the Utility, refer to the following
manual.
GOT2000 Series User's Manual (Utility)
(3) Precedence in communication settings
When settings are made by GT Designer3 or the
Utility, the latest setting is effective.
6.2.9 PLC Side Settings
POINT POINT POINT
YASKAWA PLC
For details of YASKAWA PLCs, refer to the following
manuals.
YASKAWA PLC user's Manual

Communication and port settings
Make the communication and port settings with a
peripheral tool.
*1 Set the address according to the Host Address setting on the
GOT side.
For the Host Address setting on the GOT side, refer to the
following.
6.2.8
■
Communication detail settings
*2 Only transmission speeds available on the GOT side are
shown.
Also, the setting range differs depending on the YASKAWA
PLC model.
*3 The transmission speed setting must be consistent with that
of the GOT side.
For the transmission speed setting on the GOT side, refer to
the following.
6.2.8
■
Communication detail settings
Model name Delay Time
CP-9200(H) 30ms or more
CP-9300MS
port:0 10ms or more
port:1 30ms or more
Device name Set value
Address
*1
1 to 31
Protocol MEMOBUS
Mode RTU
Transmission
speed
*2*3
4800bps, 9600bps, 19200bps, 38400bps,
57600bps
Data bit 8bits
Stop bit 1bit
Parity bit Even
Error check CRC16