Mitsubishi FX3UC Series, Руководство пользователя

Страница: 23 / 458

17
Requirement for Compliance with LVD directive
The following products have shown compliance through direct testing (of the identified standards below) and
design analysis (through the creation of a technical construction file) to the European Directive for Low
Voltage (73/23/EEC) when used as directed by the appropriate documentation.
Type : Programmable Controller (Open Type Equipment)
Models : MELSEC FX
2NC
series manufactured
*1. Compliance to BSEN61010-1 is claimed through virtue of direct compliance to IEC1010-1 and
Amendment 1.
Models : MELSEC FX
2N
series manufactured
For the products above, PLCs manufactured
before March 31st, 2002 are compliant with IEC1010-1
from April 1st, 2002 to April 30th, 2006 are compliant with EN61131-2:1994+A11:1996+A12:2000
after May 1st, 2006 are compliant with EN61131-2:2003
from August 1st, 1999 FX
2NC
-16EYR-T-DS
from October 1st, 2007 FX
2NC
-16EYR-T
Standard Remark
IEC1010-1:1990 Safety requirements for electrical
/A1:1992 equipment for measurement,
control, and laboratory use
- General requirements
BSEN61010-1 :1993
*1
The equipment has been assessed as a component for
fitting in a suitable enclosure which meets the requirements
of IEC 1010-1:1990+A1:1992
from July 1st, 1997 FX
2N
-16EYR-ES/UL
from August 1st, 2005 FX
2N
-8ER-ES/UL FX
2N
-8EYR-ES/UL
Standard Remark
IEC1010-1:1990 Safety requirements for electrical
/A1:1992 equipment for measurement, control,
and laboratory use
- General requirements
The equipment has been assessed as a component for
fitting in a suitable enclosure which meets the requirements
of IEC 1010-1:1990+A1:1992
EN61131-2:1994 Programmable controllers
/A12:1996 - Equipment requirements and tests
/A11:2000
The equipment has been assessed as a component for
fitting in a suitable enclosure which meets the requirements
of EN61131-2:1994+A11:1996+A12:2000
EN61131-2:2003 Programmable controllers
- Equipment requirements and tests
The equipment has been assessed as a component for
fitting in a suitable enclosure which meets the requirements
of EN61131-2:2003