Mitsubishi FX3U-32DP, Руководство пользователя

Страница: 58 / 74

52
FX
3U
-32DP PROFIBUS-DP Interface Block
User’s Manual
7 Parameter Setting and Network Configuration [GX Configurator-DP]
7.1 Slave Parameter Settings
7.1 Slave Parameter Settings
The slave parameters for the 32DP must be set using the DP-Master Configuration Tool. This section
describes the available parameters that are available with GX Configurator-DP.
→
For details on the "Slave Parameter Settings" dialog box,
refer to the GX Configurator-DP Software Manual.
7.1.1 Slave Properties
Set the following parameters in the Slave Properties section of the "Slave Paramenter Settings" dialog box
within GX Configurator-DP.
→
For details on the "Slave Parameter Settings" dialog box, refer to the GX Configurator-DP Software
Manual.
7.1.2 Extended User Parameters
Use the "User Param." button from the "Slave Parameter Settings" dialog box in GX Configurator-DP to
enable or disable the swap byte order. The default setting is set to "disable." The "User Param." button
opens the "Extended User Parameters" dialog box and is applicable for the Byte Swap of cyclic/acyclic I/O-
Data.
→
For details on the "Slave Parameter Settings" dialog box,
refer to the GX Configurator-DP Software Manual.
Parameter Description Default/Setting Range
Name Name of the DP-Slave Default: Slave_Nr_001
FDL address This item defines the slave address
Default: 1
Range : 0 to 125
Watchdog
Check off to enable the watchdog control for the DP-Slave
The DP-Slave monitors if the DP-Master completes the
communication process within the preset watchdog time, and if the
process exceeds the watchdog time, BFM #29 Bit 8 turns ON
Default: Not Checked
Slave Watchdog
Time
Here, users need to set the watchdog time interval of the DP-Slave
when the watchdog functionality is enabled.
The Watchdog Time must be longer than the max. PROFIBUS Cycle
Time.
→
For details on PROFIBUS Cycle Time, refer to
the respective DP-Master Manual
Range: 1 to 65025 [10ms]
min T_sdr
This is the minimum response time for a DP slave to send the
response frames to the DP master. Do not change this value. Default : 11
Range : 1 to 255
Group
Identification
Number
Check off to allocate the DP-Slave to a group or a set of groups.
The DP-Slaves in the same group operate synchronously
−
Slave is active
Check off for the master to determine the presence of the specified
DP-Slave
This helps users sort out the physical network connections
Default : Checked off
Sync (Output) Check off set the output data ready for the SYNC mode Default : Not Checked
Freeze (Input) Check off to set the input data ready for the FREEZE mode Default : Not Checked
Swap I/O Bytes
in Master Check off to swap the byte order for a PROFIBUS DP Module having
the reversed-byte word format
Default : Not Checked
DP V1/V2 Slave
Parameters
Click this button to open the <DP V1/V2 Slave Parameters> dialog
box. Use the options to enable/disable DP-V1 Support and to set
support for Diagnostic Alarm data. The default setting for "DP V1
support enabled" is "Not checked"
−