Mitsubishi MOTORS Mirage 2012, Руководство пользователя

Страница: 123 / 250

l The ABS can be used after the vehicle has
reached a speed over approximately 10 km/h
(6 mph). It stops working when the vehicle
slows below approximately 5 km/h (3 mph).
CAUTION
l The ABS cannot prevent accidents. It is
your responsibility to take safety precau-
tions and to drive carefully.
l To prevent failure of the ABS, be sure all
4 wheels and tyres are the same size and
the same type.
l Do not install any aftermarket limited-
slip differential (LSD) on your vehicle.
The ABS may stop functioning properly.
ABS warning lamp
E00607201308
If there is a malfunction in the system, the ABS
warning lamp will come on.
Under normal conditions, the ABS warning lamp
comes on when the ignition switch is turned to the
“ON” position or the operation mode is put in ON
and goes off a few seconds later.
CAUTION
l Any of the following indicates that the
ABS is not functioning and only the stand-
ard brake system is working. (The stand-
ard brake system is functioning normal-
ly.) If this happens, we recommend you to
have your vehicle inspected as soon as pos-
sible.
• When the ignition switch is turned to
the “ON” position or the operation
mode is put in ON, the warning lamp
does not come on or it remains on and
does not go off.
• The warning lamp comes on while driv-
ing
If the warning lamp illuminates while
driving
E00607301383
If only the ABS warning lamp illuminate
Avoid hard braking and high-speed driving. Stop
the vehicle in a safe place.
Restart the engine and check to see whether the
lamp goes out after a few minutes driving; if it then
remains off during driving, there is no problem.
However, if the warning lamp do not disappear, or
if they come on again when the vehicle is driven,
we recommend you to have the vehicle checked.
If the ABS warning lamp and brake warning
lamp illuminate at the same time
The ABS and brake force distribution function may
not work, so hard braking could make the vehicle
unstable.
Avoid hard braking and high-speed driving. Stop
the vehicle in a safe place and we recommend you
to have it checked.
After driving on icy roads
E00618800206
After driving on snow or icy roads, remove any
snow and ice which may have accumulated around
the wheels. On vehicles that have an ABS, be care-
ful not to damage the wheel speed sensors (A) or
the cables located at each wheel.
Front Rear
Starting and driving
4-29
OA0X13E4
4