Mitsubishi MOTORS Lancer Evolution 2009, Руководство пользователя

Страница: 133 / 362

l If the lamps do not turn on or off with the
switch in the “AUTO” position, manually op-
erate the switch and we recommend you to
have your vehicle checked.
Vehicles with Daytime Running Lamp*
When the engine is running and the lamp switch is
set to the “AUTO” or “OFF” position, the low
beam of the headlamps, tail lamp etc., will illumi-
nate.
NOTE
l The daytime running lamp can be deactivated.
For further information, we recommend you
to consult a MITSUBISHI MOTORS Author-
ized Service Point.
The regulations concerning daytime running
lamp may differ from country to country.
Find out and follow the laws and regulations
of the area you’re driving in.
Lamps (headlamps, fog lamp, etc.) au-
to-cutout function
E00532700051
l
If, while the lamp switch is in the “ ” posi-
tion, the ignition switch is turned to the
“LOCK” position or “ACC” position, or the
key is removed from the ignition switch, the
lamps automatically go out when the driver’s
door is opened.
[When the engine was started using the key]
• If the key is removed and the driver’s
door is opened, a buzzer sounds at a high
pitch intermittently to remind the driver
to turn off the lamps.
[When the engine was started using the key-
less operation function]
• If the ignition switch is turned to the
“LOCK” position and the driver’s door is
opened, a buzzer sounds at a high pitch in-
termittently to remind the driver to turn
off the lamps.
l If the ignition switch is turned to the
“LOCK” position or “ACC” position, or the
key is removed from the ignition switch,
while the lamp switch is in the “
” posi-
tion, the lamps will remain on for about
3 minutes while the driver’s door is shut and
will then automatically go out.
NOTE
l The lamp auto-cutout will not function when
the lamp switch is in the “
” position.
l The lamp auto-cutout function can also be dis-
abled.
For further information, we recommend you
to consult a MITSUBISHI MOTORS Author-
ized Service Point. On vehicles equipped
with Mitsubishi Multi-Communication Sys-
tem (MMCS), screen operations can be used
to make the adjustment. Refer to the separate
owner’s manual for details.
When you want to keep the lamps on:
1. Turn the lamp switch in the “OFF” position
while the ignition switch is in the “LOCK”
or “ACC” position.
2. Turn on the lamps with the switch in the
“ ” or “ ” position again, then the
lamps will remain on.
NOTE
l When the engine was started using the key, if
the driver’s door is opened and the key is re-
moved, the lamp monitor buzzer sounds at a
high pitch intermittently.
The buzzer stops when the driver’s door is
closed. (The warning is also displayed on the
multi-information display.)
The buzzer stops in the following manner.
• Turn the lamp switch to the “OFF” posi-
tion.
• Close the driver’s door.
Instruments and controls
3-39
3