Mitsubishi MOTORS Eclipse Cross 2019, Руководство пользователя

Страница: 446 / 602

CAUTION
l
[For 2WD vehicles equipped with the Active
Stability Control (ASC)]
If the vehicle is towed with the ignition
switch in the “ON” position or the operation
mode in ON and only the front wheels or on-
ly the rear wheels raised off the ground
(Type B or C), the ASC may operate, result-
ing in an accident. When towing the vehicle
with the rear wheels raised, turn the ignition
switch to the “ACC” position or put the op-
eration mode in ACC. When towing the ve-
hicle with the front wheels raised, keep the
ignition switch or the operation mode as fol-
lows.
[Except vehicles equipped with keyless op-
eration system]
The ignition switch is in the “LOCK” or
“ACC” position.
[Vehicles equipped with keyless operation
system]
The operation mode is in OFF or ACC.
Towing with rear wheels off the
ground (Type B - 2WD vehicles
with M/T only)
Place the gearshift lever in the “N” (Neutral)
position.
Turn the ignition switch to the “ACC” posi-
tion or put the operation mode in ACC and
secure the steering wheel in a straight-ahead
position with a rope or tiedown strap. Never
place the ignition switch in the “LOCK” po-
sition or put the operation mode in OFF when
towing.
Towing with front wheels off
the ground (Type C - 2WD ve-
hicles only)
Release the parking brake.
Place the gearshift lever in the “N” (Neutral)
position (M/T) or the selector lever in the
“N” (Neutral) position (CVT).
Emergency towing
If towing service is not available in an emer-
gency, your vehicle may be temporarily tow-
ed by a rope secured to the towing hook.
If your vehicle is to be towed by another ve-
hicle or if your vehicle tows another vehicle,
pay careful attention to the following points.
If your vehicle is to be towed by
another vehicle
1. The front towing hooks are located as
shown in illustration. Secure the tow
rope to the front towing hook.
CAUTION
l Using any part other than the designated
towing hook could result in damage to vehi-
cle body.
NOTE
l Using a wire rope or metal chain can result
in damage to the vehicle body. It is best to
use a non-metallic rope. If you use a wire
rope or metal chain, wrap it with cloth at any
point where it touches the vehicle body.
l Take care that the tow rope is kept as hori-
zontal as possible. An angled tow rope can
damage the vehicle body.
l Secure the tow rope to the same side towing
hook, to keep the tow rope as straight as pos-
sible.
2. Keep the engine running.
Towing
8-28
OGKE20E1
For emergencies
8