Mitsubishi MOTORS Eclipse Cross 2019, Руководство пользователя

Страница: 388 / 602

6. For confirmation purposes, the voice
guide will say “Password <4-digit pass-
word>. Is this correct?” Answer “Yes.”
Answer “No” to return to the password
input in Step 5.
7. When the registration of the password is
completed, the voice guide will say
“Password is enabled” and the system
will return to the main menu.
NOTE
l Password will be required to access the sys-
tem after the next ignition cycle.
l It is required for a little time after engine
stop that the entered password is actually re-
corded in the system.
If the ignition switch or the operation mode
is made to ACC or ON or the engine is star-
ted immediately after engine stop, there is a
case when the entered password is not recor-
ded in the system. At this time, please try to
enter the password again.
Entering the password
If a password has been set and the security
function is enabled, the voice guide will say
“Hands-free system is locked. State the pass-
word to continue” when the SPEECH button
is pressed to enter voice recognition mode.
Say the 4-digit password number to enter the
password.
If the entered password is wrong, the voice
guide will say “<4-digit password>, Incorrect
password. Please try again.” Enter the correct
password.
NOTE
l You can re-enter the password as many
times as you want.
l If you have forgotten your password, say
“Cancel” to quit the voice input mode and
then check with a MITSUBISHI MOTORS
Authorized Service Point.
Disabling the password
Use the following procedure to turn off the
security function by disabling the password.
NOTE
l System must be unlocked to disable the
password.
1. Press the SPEECH button.
2. Say “Setup.”
3. Say “Password.”
4. The voice guide will say “Password is
enabled. Would you like to disable it?”
Answer “Yes.”
Answer “No” to cancel the disabling of
the password and return to the main
menu.
5. When the disabling of the password is
completed, the voice guide will say
“Password is disabled” and the system
will return to the main menu.
Speaker enrollment function
The Bluetooth
®
2.0 interface can use the
speaker enrollment function to create a voice
model for one person per language.
This makes it easier for the Bluetooth
®
2.0
interface to recognise voice commands said
by you.
You can turn a voice model registered with
the speaker enrollment function on and off
whenever you want.
Speaker enrollment
It takes approximately 2 to 3 minutes to com-
plete the speaker enrollment process.
To ensure the best results, run through the
process while in the driver’s seat, in an envi-
ronment that is as quiet as possible (when
there is no rain or strong winds and the vehi-
cle windows are closed). Please turn off your
phone while in speaker enrollment to prevent
interruption of the process.
Use the following procedure for speaker en-
rollment.
1. Stop your vehicle in a safe area, put the
gearshift lever (M/T) in the “N” (Neu-
tral) position, or the selector lever (A/T
Bluetooth
®
2.0 interface*
7-60
OGKE20E1
For pleasant driving
7