Mitsubishi MOTORS Eclipse Cross 2019, Руководство пользователя, Страница: 258 / 602

To temporarily increase or de-
crease the speed
To temporarily increase the
speed
Depress the accelerator pedal as you would
normally. When you release the pedal, you
will return to your set speed.
NOTE
l In some driving conditions, the set speed
driving may be deactivated. If this happens,
refer to “To activate” on page 6-70 and re-
peat the speed setting procedure.
To temporarily decrease the
speed
Depress the brake pedal to decrease the
speed. To return to the previously set speed,
push up the “RES +” switch (C).
Refer to “To resume the set speed” on page
6-73.
To deactivate
The set speed driving can be deactivated as
follows:
l
Press the CRUISE CONTROL ON/OFF
switch (A) (Cruise control will be turned
off.)
l Press the “CANCEL” switch (D).
l Depress the brake pedal.
The set speed driving is deactivated automat-
ically in any of the following ways.
l When you depress the clutch pedal (on
vehicles equipped with M/T).
l
When your speed slows to approximate-
ly 15 km/h (10 mph) or more below the
set speed because of a hill, etc.
l When your speed slows to approximate-
ly 30 km/h (20 mph) or less.
l
When the Active Stability Control
(ASC) starts operating.
Refer to “Active stability control (ASC)”
on page 6-66.
WARNING
l On vehicles equipped with A/T or CVT,
although the set speed driving will be de-
activated when shifting to the “N” (Neu-
tral) position, never move the selector lev-
er to the “N” (Neutral) position while
driving.
You would have no engine braking and
could cause a serious accident.
Also, the set speed driving may be deactiva-
ted as follows:
l When the engine speed rises and ap-
proaches the tachometer’s red zone (the
red-coloured part of the tachometer di-
al).
Cruise control*
6-72
OGKE20E1
Starting and driving
6