Mitsubishi MOTORS Eclipse Cross 2019, Руководство пользователя

Страница: 250 / 602

• Driving on gravel or snow-covered
roads.
• Driving with snow traction device
(tyre chains) installed.
• Driving on roads where the road sur-
face is pitted or has other differences
in surface height.
• Driving on uneven road surfaces.
l Operation of ABS is not restricted to sit-
uations where brakes are applied sud-
denly. This system may also prevent the
wheels from locking when you drive
over manholes, steel roadwork plates,
road markings, or any uneven road sur-
face.
l When the ABS is activated, you may
feel the brake pedal pulsation and the vi-
brations of the vehicle body and steering
wheel. It may also feel as if the pedal re-
sists being pressed.
In this situation, simply hold the
brake pedal down firmly. Do not
pump the brake, which will result in
reduced braking performance.
l
An operation noise may be emitted from
the engine compartment in the following
situations. The sound is associated with
checking the operations of the ABS. At
this time, you may feel a shock from the
brake pedal if you depress it. These do
not indicate a malfunction.
• When the ignition switch is set to the
“ON” position.
• When the vehicle is driven for a while
after the engine is turned on.
l The ABS can be used after the vehicle
has reached a speed over approximately
10 km/h (6 mph). It stops operating
when the vehicle slows below 5 km/h
(3 mph).
CAUTION
l The ABS cannot prevent accidents. It is your
responsibility to take safety precautions and
to drive carefully.
l To prevent failure of the ABS, be sure all
four wheels and tyres are the same size and
the same type.
l Do not install any aftermarket limited-slip
differential (LSD) on your vehicle. The ABS
may stop functioning properly.
ABS warning lamp/display
Warning lamp
Warning display
If there is a malfunction in the system, the
ABS warning lamp will come on and the
warning display will appear on the informa-
tion screen in the multi-information display.
Under normal conditions, the ABS warning
lamp only comes on when the ignition switch
is turned to the “ON” position or the opera-
tion mode is put in ON and goes off a few
seconds later.
CAUTION
l Any of the following warning lamp/display
behaviour indicates that the ABS is not func-
tioning and only the standard brake system
is working. (The standard brake system is
functioning normally.) If this happens, we
recommend you to have your vehicle inspec-
ted as soon as possible.
• When the ignition switch is turned to the
“ON” position or the operation mode is
put in ON, the warning lamp does not
come on or it remains on and does not go
off
• The warning lamp comes on while driving
• The warning display appears while driv-
ing
If the warning lamp/display il-
luminate while driving
If only the ABS warning lamp/
display illuminate
Avoid hard braking and high-speed driving.
Anti-lock brake system (ABS)
6-64
OGKE20E1
Starting and driving
6