Mitsubishi Electric VS-60HS12U, Руководство по установке

Страница: 26 / 64

26
VS-60HS12U Set-up Manual
Geom
et
ry
A
lig
nm
en
t
3
3
.
.
3
3
G
G
e
e
o
o
m
m
e
e
t
t
r
r
y
y
A
A
l
l
i
i
g
g
n
n
m
m
e
e
n
n
t
t
Projected images from the engine unit can be aligned to be precisely located on the screen.
Adjustment menu
Select SYSTEM SETTING > MAINTENANCE > GEOM.
ALIGNMENT menu.
Geometry alignment cannot be adjusted on the
following condition.
-
When the window position is outside the monitor.
In this case, icon is shown on the OSD menu.
Please set following menu(Page35, 35)
DISPLAY MEMORY
＞
WINDOW1
＞
WINDOW ARRANGEMENT /TILE
- Window non-display setting.
In this case, please set following menu. (Page45)
DISPLAY MEMORY
＞
WINDOW1
＞
ENABLED / ON
-SCREEN MUTE (Page23)
In this case, please push MUTE button again.
1
Up/down buttons select modes to be adjusted and
left/right buttons adjusts.
2 GEOM. ALIGNMENT
Set ‘ON’ with all monitors to be adjusted. Press [TEST]
button on the remote control in this mode to show
on or off the geometry crosshatch pattern (GEOM.
CROSSHATCH).
•
Geometry alignment function applies only for input
signal and ‘GEOM. CROSSHATCH’. And this function
does not apply for OSD menu and the internal test
patterns except for the ‘GEOM. CROSSHATCH’. The
display position and size of the OSD menu does not
change by ON/OFF of GEOM. ALIGNMENT function.
3
H-ZOOM
Horizontal size can be adjusted by left and right
button.
4 V-ZOOM
Vertical size can be adjusted by left and right button.
5
H- POSITION
It can adjust the whole output position in the
horizontal direction by left and right button.
6
V- POSITION
It can adjust the whole output position in the vertical
direction by left and right button.
7
FINE ADJUST 5x5
Select ‘FINE ADJUST 5x5‘ and press enter button , it will
become Grid selection mode and Grid of 5x5 will be
displayed on the screen.
Grid select mode
-It can select the adjustment grid by left, right, top
and down button. Selected grid is displayed with
green.
-Press ENTER button in Grid selection mode, it will
become Grid adjustment mode.
-Press ESC button in Grid selection mode, it will return
to GEOM. ALIGNMENT menu.
Grid adjustment mode
-Selected grid is displayed with red in Grid adjustment
mode.
- Selected grid can be adjusted by left, right, top and
down button.
-Press ESC button in Grid adjustment mode, it will
return to Grid selection mode.
Test Pattern
GEOM.
CROSSHATCH)
Screen
Enter Key
ESC Key
Grid select mode
Grid Adjustment mode