Mitsubishi Electric VS-60HS12U, Руководство по установке

Страница: 15 / 64

REV 1.0
15
Cu
be
s
ta
ck
in
g
2.3.2 Base stands and cubes assembling
Prepare suitable base stands by yourself to fit the
installation site.
1
Make base stands both level and plumb by means of
a level.
2
Place a cube to be in the bottom row on the base
stand.
3 Fix the cube at 4 points with supplied hex socket
head bolts, spring washers and flat washers.
•
Tighten the bolts with appropriate force
(suggested torque: 3.9Nm).
To access the rear fixing points, open the cover and
the partition. Take off the cover by pulling the latch
after loosening the screw and the partition by
loosening four screws.
4 Place an adjacent bottom row cube on the base
stand and fix it in the same way.
5 Connect these cubes together at 4 points with
supplied hex socket head bolts, spring washers and
flat washers.
To access the rear fixing points, open the covers on
both sides by pulling the latches.
•
When making a curved display wall and you have
to remove the connecting plates, put substitute
washers with equivalent strength on the holes.
6 Place other cubes for the upper row on the row of
cubes.
7 Connect these cubes vertically and horizontally in
the same manner as step 3 and 5.
•
To prevent cubes from falling, make sure the cubes
are stably assembled by checking that they are
level.
8
After all cubes are joined together, stop up unused
holes on both sides of the cubes with supplied seals
for joint holes.
Base stands
Adjusters
Cube
Hex socket bolts
Spring washers
Flat washers
Hex socket bolts
Spring washers
Flat washers
Connecting plate
Cover
Latch
Seals for Joint holes
Partition
Cover
Latch
Screw
Screws
Rear fixing points