EN-18
Menu operation (continued)
5. Setting menu
6. Language menu
7. Factory Default menu
Menu option
Setting
Feature description
Menu Position
5 options
Choose the menu location on the display screen.
Mounting
4 options
Adjust the picture to match the orientation of the projector: upright or
upside-down, in front of or behind the screen. Invert or reverse the
image accordingly.
Logo
On, Off
Choose to display the logo or not.
Signal Type
RGB
For VGA signal
YCbCr
/
YPbPr
For Component I,P signal
Lamp Time
Display the lamp's elapsed operating time (in hours).
•
The displayed lamp time is based on low lamp mode setting.
(The lamp lifetime is 3000 hours.)
Lamp Time Reset
Yes, No
Reset the lamp time to 0 hours.
Auto Power On
Yes, No
When this mode is set to Yes, the lamp is automatically lit when the
power cord is plugged in the wall outlet. Select Yes when you set the
projector at the ceiling.
•
When the lamp is off, the projector is in standby. Use the remote
control to turn on the lamp.
Auto Power Off
No, 15-60 Min.
Selects a desired timer setting until the projector enters the standby
mode when there is no signal input from the source.
Auto Source
Yes, No
Automatically scan the input source.
Lamp Mode
Standard
Select this setting when you want to view images in a well-lit room.
Low
Select this setting when you want to view images at a moderate light
intensity. The operating sound is consequently reduced, and the lamp
lifetime becomes longer.
•
When this mode is switched, projected images may flicker.
•
If this mode is frequently switched, the lamp may be deteriorated.
•
The default setting is Standard when shipment.
•
The Lamp Mode cannot be switched for about 1 minute after the
lamp is on.
OSD Timeout
5 - 60 sec
Duration OSD menu stays active (at idle state by second).
Menu option
Setting
Feature description
Language
11 languages
Select the language used by the on-screen menu.
Menu option
Setting
Feature description
Factory Default
Yes, No
Restore all menu settings to factory default settings.
