5 Maintenance and Inspection
Resetting the origin
(4) All axis origin setting
1) Refer to the paragraphs from
J1 axis origin setting (mechanical stopper)"
Page 115, "(3) J3 and J4 axis origin setting
(mechanical stopper)"
of how to adjust the origins of the J1 to J4
axes. Line up the ABS marks for the J4 axis and
move the other axes into contact with the
mechanical stoppers. At this point, the robot will
have the posture shown below
2) Press the [1] key, and display the Origin set
-
ting selection screen.
3) Press the [2] key, and display the Mechanical
stopper selection screen.
4) Input "1" into the J1 to J4 axis. Set "0" to
other axes.
5) Press the [EXE] key, and display Confirmation
screen.
6) Press the [F1] key, and the origin position is
set up.
7) Setting of the origin is completed.
8) Refer to
Page 130, "5.6.5 Recording the origin
in this manual, and record the origin data
on the origin data seal.
The origin settings are completed by the mechanical stopper method.
SPACE
<ORIGIN/BRAKE>
1.ORIGIN
2.BRAKE
CLOSE
123
<ORIGIN> MECH
J1(
1
) J2(
1
) J3(
1
)
J4(
1
) J5( ) J6( )
J7( ) J8( )
CLOSE
123
<ORIGIN> MECH
CHANGE TO ORIGIN. OK?
No
123
Yes
<ORIGIN> MECH COMPLETED
J1(
1
) J2(
1
) J3(
1
)
J4(
1
) J5( ) J6( )
J7( ) J8( )
CLOSE
123
<ORIGIN>
1.DATA
2.MECH
3.TOOL 4.ABS
5.USER
CLOSE
123