Mitsubishi Electric MELSERVO MR-JET-G Series, Руководство пользователя

Страница: 84 / 164

82
1 SERVO PARAMETER DETAILS
1.7 Extension setting 3 servo parameters group ([Pr. PF_ _ ])
[Pr. PF29_Function selection F-10 (*FOP10)]
[Pr. PF29.1_State selection with forced stop in progress]
Select the PDS state transition for when the forced stop is in progress.
Select whether to enable/disable use of the Quick stop function when the servo amplifier detects a forced stop signal off
during operation of the servo motor.
0: Operation enabled
1: Quick stop active
[Pr. PF31_Machine diagnosis function - Friction judgment speed
(FRIC)]
Set the servo motor speed to divide the friction estimation area between low-speed and high-speed in the friction estimation
process of machine diagnosis.
When the maximum operation speed is under the rated speed, it is recommended to set half the value of the maximum
operation speed.
When "0" is set, the judgment speed is half of the rated speed.
The setting value will be clamped at the maximum speed. When changing the speed to the permissible speed, set the speed
in [Pr. PA28.4 Speed range limit selection].
By setting [Pr. PF34.6 Friction estimate area judgment speed setting] to "1" (automatic setting), this servo parameter value will
be automatically calculated from the operation pattern during servo motor driving and overwrite the value.
Initial value Setting range Ver.
00000000h Refer to the relevant detail No. Refer to the relevant detail No.
Initial value Setting range Ver.
0h Refer to the text B2
Initial value Setting range Ver.
0 [r/min], [mm/s] 0 to 65535 A4
0 r/min
Maximum speed in operation
Setting value of [Pr. PF31]
Operation pattern
Servo motor
speed
Forward direction
Reverse direction