Mitsubishi Electric MELSERVO MR-JET-G Series, Руководство пользователя

Страница: 101 / 164

1 SERVO PARAMETER DETAILS
1.8 Motor extension setting servo parameters group ([Pr. PL_ _ ])
99
1
[Pr. PL17.1_Load to motor mass ratio/load to motor inertia ratio selection]
Select the load to mass of the linear servo motor primary-side ratio used for the minute position detection method. Select a
value closest to the actual load.
Refer to the following table for setting values.
[Pr. PL18_Magnetic pole detection - Minute position detection
method - Identification signal amplitude (IDLV)]
Set an identification signal amplitude to be used in the minute position detection method.
This servo parameter is enabled when [Pr. PL08.0 Magnetic pole detection method selection] is set to "4".
When "0" is set, the amplitude will be 100 [%].
Initial value Setting range Ver.
0h Refer to the text B2
Setting value of [Pr. PL17.1] Load to motor mass ratio
0 10 times or less
1 10 multiplier
2 20 multiplier
3 30 multiplier
4 40 multiplier
5 50 multiplier
6 60 multiplier
7 70 multiplier
8 80 multiplier
9 90 multiplier
A 100 multiplier
B 110 multiplier
C 120 multiplier
D 130 multiplier
E 140 multiplier
F 150 times or more
Initial value Setting range Ver.
0 [%] 0 to 200 B2