Mitsubishi Electric Melservo-J5 MR-J5 Series, Руководство пользователя

Страница: 28 / 446

26
2 INSTALLATION
2.1 Mounting direction and clearances
2
INSTALLATION
Precautions
• Install the servo amplifier and regenerative resistor on incombustible material. Installing them either directly on or near
combustibles may lead to smoke or a fire. In addition, the servo amplifier must be installed in a metal cabinet.
• Provide an adequate protection to prevent the following matter from entering the servo amplifier: conductive matter such as
screws and metal fragments, and combustible matter such as oil.
• Devices such as the servo amplifier regenerative resistor and servo motor may become hot. Take safety measures such as
providing covers.
• Do not stack in excess of the specified number of product packages.
• Do not hold the front cover, cables, or connectors when carrying the servo amplifier. Doing so may cause the servo
amplifier to drop.
• To prevent a malfunction, do not drop the servo amplifier or servo motor or subject them to impacts.
• Install the servo amplifier and servo motor in a place that can support their weight as stated in the user's manual.
• Do not get on the equipment or put a heavy load on it.
• Do not install or operate a servo amplifier that is missing parts or is damaged.
• To prevent a malfunction, do not block the intake and exhaust areas of the servo amplifier.
• Do not subject connectors to impacts. Doing so may cause a connection failure, malfunction, or other failures.
• Use the product within the specified environment. For the environment, refer to "Servo amplifier standard specifications" in
the User's Manual (Introduction).
• To prevent a fire or injury from occurring in the event of an earthquake or other natural disaster, securely install, mount, and
wire the servo amplifier as stated in the user's manual.
• When the product has been stored for an extended period of time, contact your local sales office.
• When handling the servo amplifier, be careful with the edges of the servo amplifier.
• Fumigants that are used to disinfect and protect wooden packaging from insects contain halogens (such as fluorine,
chlorine, bromine, and iodine) cause damage if they enter our products. Please take necessary precautions to ensure that
any residual materials from fumigants do not enter our products, or perform disinfection and pest control using a method
other than fumigation, such as heat treatment. Perform disinfection and pest control on the wooden packaging materials
before packing the products.
• Provide an external emergency stop circuit to stop the operation and shut-off the power immediately.
• For equipment in which the moving part of the machine may collide against the load side, install a limit switch or stopper to
the end of the moving part.
2.1
Mounting direction and clearances
Precautions
• The servo amplifier must be installed in the specified direction.
• To prevent a malfunction, maintain the specified clearances between the servo amplifier and cabinet walls or other
equipment.
• When using the servo amplifier at an ambient temperature exceeding 55 °C and up to 60 °C, circulate air so that the air at
the top and bottom of the servo amplifier does not stagnate.