Mitsubishi Electric MELSERVO-J4 series, Инструкция по эксплуатации

Страница: 518 / 646

516
16 FULLY CLOSED LOOP SYSTEM
16.1 Functions and configuration
System configuration
For a linear encoder
■
MR-J4-_GF_ servo amplifier
*1 Applicable for the absolute position detection system when an absolute position linear encoder is used.
In that case, a battery is not required.
■
MR-J4-_GF_-RJ servo amplifier
*1 Applicable for the absolute position detection system when an absolute position linear encoder is used.
In that case, a battery is not required.
CN2
Servo amplifier
CC-Link IE compatible
simple motion module
CC-Link IE
Position command
control signal
Table
Two-wire type serial interface compatible linear encoder *1
Load-side encoder signal
Servo motor encoder signal
Linear encoder head
Servo motor
CN2L
CN2
A/B/Z-phase pulse train interface compatible linear encoder
or two-wire/four-wire type serial interface compatible linear encoder
*1
(A/B/Z-phase pulse train interface
or serial interface)
Servo amplifier
CC-Link IE compatible
simple motion module
CC-Link IE
Position command
control signal
Table
Load-side encoder signal
Servo motor encoder signal
Linear encoder head
Servo motor