Mitsubishi Electric MELSERVO EMC, Руководство по установке

Страница: 22 / 44

20
4 EMC COUNTERMEASURE PARTS
4.4 Cable clamp fitting
4.4
Cable clamp fitting
Generally, connecting the grounding wire of the shielded wire to the SD terminal of the connector provides a sufficient effect.
However, the effect can be increased when the shielded wire is connected directly to the ground plate as shown below. Install
the ground plate near the servo amplifier for the encoder cable. Peel part of the cable insulator to expose the external
conductor, and press that part against the ground plate with the cable clamp. If the cable are thin, bunch several cables
together and clamp them in place.
The cable clamp comes as a set with the grounding plate.
[Unit: mm]
• Dimensions
[Unit: mm]
*1 Screw hole for grounding. Connect it to the ground plate of the cabinet.
Precautions
• The motor cable (single cable type) has no shield on the outermost circumference. Therefore, to ground the motor cable
with a cable clamp, use a motor cable (dual cable type).
Model A B C Accessory fittings
AERSBAN-DSET 100 86 30 Clamp A: 2 pcs.
AERSBAN-ESET 70 56

Clamp B: 1 pc.
Clamp fitting L
A 70
B 45
40
Strip the cable insulator
of the clamped area
Cutter
Cable
Clamp fittings
(A, B)
Grounding plate
Cable
External conductor
Clamp section diagram
11
24
0
3
7
35
C A
17.5
6
35
22
6
B ± 0.3
30
10
24
+0.3
0
-0.2
Grounding plate
Clamp fitting
2- φ 5 hole
Mounting hole
L or less
M4 screw
*1