Mitsubishi Electric MELSEC-L LD75D, Руководство пользователя

Страница: 367 / 818

365
CHAPTER 9 MAJOR POSITIONING CONTROL
9
9.
2 Set
ting t
he Pos
itioning
D
at
a
*1 If the item is set, the error "Continuous path control not possible" (error code: 516) or "New current value not possible"
(error code: 515) will occur at a start.
*2 Setting value invalid Use the initial value or a value within the setting range.
*3 Two control systems are available: the absolute (ABS) system and incremental (INC) system.
*4 Set the M code for the reference axis and the number of pitch for the linear interpolation axis.
Remark
It is recommended that the "positioning data" be set whenever possible with GX Works2. Execution by program uses many
programs and devices. The execution becomes complicated, and the scan times will increase.
 : Setting always required,  : Set according to requirements,  : Setting not possible
*5
,  : Setting not required
*6
*5 If the item is set, the error "Continuous path control not possible" (error code: 516) or "New current value not possible"
(error code: 515) will occur at a start.
*6 Setting value invalid Use the initial value or a value within the setting range.
Setting items for positioning data
Position-
speed
switching
control
Other control
NOP
instruction
Current value
changing
JUMP instruction
LOOP
instruction
LEND
instruction
[Da.1]
Operation
pattern
Independent
positioning control
(Positioning
complete)
     
Continuous
positioning control
     
Continuous path
control
     
[Da.2] Control system
Forward run
speed/posi-
tion
Reverse run
speed/posi-
tion
NOP
instruction
Current value
changing
JUMP instruction
LOOP
instruction
LEND
instruction
[Da.3] Acceleration time No.      
[Da.4] Deceleration time No.      
[Da.5] Axis to be interpolated
     
[Da.6]
Positioning address/movement
amount
 
Change
destination
address
  
[Da.7] Arc address      
[Da.8] Command speed      
[Da.9] Dwell time
  
JUMP destination
positioning data No.
 
[Da.10] M code   
Condition data No. at
JUMP
No. of
repetition

[Da.27] M code ON signal output timing
     
[Da.28] ABS direction in degrees      
[Da.29]
Interpolation speed designation
method
     