Mitsubishi Electric MELSEC iQ-F FX5UC Series, Руководство пользователя

Страница: 242 / 282

240
14 PROCEDURES BEFORE OPERATION
14.6 Connecting a Personal Computer
When Ethernet cable is used (connection via a hub)
To connect to Ethernet via a hub, setting of both the personal computer and the CPU module is required.
Connect a personal computer to the CPU module via a hub, following the procedure below.
Connection of the Ethernet cable
GX Works3 settings
Use the [Find] button in the "programmable controller side I/F Detailed Setting of CPU Module". The IP
address of the connected CPU module can be searched and can be set to "IP Address".
Setting the CPU module
■
Setting module parameters
From the engineer tool, set on the" Module Parameter Ethernet Port" window.
In [Navigation], select [Parameter]  Module model name  [Module Parameter]  [Ethernet Port]  [Basic Settings]
 [Own Node Settings].
1.
Connect a personal computer to the CPU module via a
hub.
No. Item Selection item Internal setting Input value
1) Personal computer side I/F Ethernet Board  
2) programmable controller
side I/F CPU module Connection via HUB IP Address 192.168.3.250
Response Wait Time 2 seconds
Other Station Setting No Specification Check at Communication Time 30 seconds
Retry Times 0 times
1.
Set the IP address on the CPU module side and click
the [Apply] button (1).
2.
Set the connection. From the "Module Parameter
Ethernet Port" window, select [Basic Settings]

[External Device Configuration]  [Detailed Setting] 
[Ethernet Configuration (Built-in Ethernet Port)].
3.
Drag and drop "MELSOFT Connection Module" (2) from
the "Module List" to the left side of the window. Select
the protocol corresponding to the external device in
"Protocol" (3).
Hub
(1)
(2) (2) (2)
(3) (3) (3)