Mitsubishi Electric ME96SSHA-MB, Руководство пользователя

Страница: 15 / 70

14
3.
Setting
3.1.
Setting flow
To measure, it is necessary to use Setting mode to set the phase wire system, VT / direct voltage, and CT primary current.
From Operation mode, move to Setting mode and then set necessary items. Factory default settings will be used for items
that you do not set.
Only the settings in Setting menu 1 (basic setting) are needed for normal use. For more information about the settings, refer
to page 16 and after.
For more information about the factory default settings, refer to the setting table on page 67.
CAUTION
Keep in mind that when a setting is changed, the related setting items and measurement data
will be reset to the default settings. (Refer to page 31.)
Measurement Display Setting Menu End
End Display
CANCEL Display
Automatic migration.
Time constant for
current demand
Frequency
CT current
VT/direct
voltage
Display
Pattern
Phase
wire system
Setting Menu
1
Setting Menu
2
Setting Menu
3
Cancel the settings.
Save the setting
.
Instrument restart
or
Factory default setting
Operation Mode
※ 2
※ 1
Password Protection Display
Example of Setting Mode
Example of Setting Value
Confirmation Mode
Power factor
scale
Active power
scale
Voltage scale
Current scale
Harmonics
display
Changes
Password
MODBUS®RTU
address
MODBUS®RTU
baud rates
MODBUS®RTU
parity
MODBUS®RTU
stop bit
ON
Blinking