Mitsubishi Electric GT14, Руководство пользователя, Страница: 1491 / 1546

56
CONNECTION T
O
L
S
IN
DUST
R
IA
L
SY
STEMS PLC
57
CONNECTION T
O
SI
CK SAFE
T
Y
CONTROL
LER
58
CONNE
C
T
ION T
O
SI
EME
N
S PLC
59
CON
N
ECT
ION
T
O
HI
RA
TA
C
O
RPOR
AT
ION
HN
C C
O
NT
ROL
LE
R
60
CONNECTION
T
O
MURA
TEC
CONT
ROLLE
R
61
MICROCOMPUTER C
O
NNECTION
(SERI
A
L)
62
MICROCOMPUTER CONNECTION (ETHERNET)
63
MODBUS
(R)/
R
T
U
CONNECTION
62. MICROCOMPUTER CONNECTION (ETHERNET)
62.4 Message Formats
62 - 45

Error code list
In the case of format 5 (Digital Electronics Corporation's memory link method), the details (error code) of the error are
appended to the response message during faulty communication.
The following shows error code, error contents, cause, and measures.

Precautions
(1) Batch reading/writing crossing over different devices
When using the batch read (R) or batch write (W) command, do not batch read/write crossing over the different
devices.
This will cause an error response.
(2) Storage order for 32-bit data
To use the program of Digital Electronics Corporation's memory link method with [32bit Order] setting to
GOT1000 series, set [HL Order] to [32bit Order] for [Communication Detail Settings] when 32-bit data is set for
GOT-A900 series.
With setting [LH Order], the order of upper bits and lower bits are reversed when the GOT displays and writes
32-bit data.
Error code Description Measures
10
H
Command error
An unsupported command was used.
• Review the contents of the message to transmit.
• Check the commands in the message.
( 62.4.2 List of commands)
12
H
Message length error
The upper limit of the data length that can be received by
the GOT has been exceeded.
FA
H
Address error
The start address of the read/write device is out of range.
• Review the contents of the message to transmit.
• Check whether the non-existent data is set (e.g. setting "07" at the day of
the week) as clock data.
FB
H
Exceeded number of points error
The read/write range exceeded the device range.
• Review the contents of the message to transmit.
• Check the devices that can be used and the device ranges.
( 62.3 Device Data Area)
FC
H
Message format error
The format of the received message has error.
• Check the settings of "Communication Detail Settings".
• Review the contents of the message to transmit.
FF
H
Timeout error
There is no response from the GOT, or the station of the
specified address does not exist.
• Check the communication cable and communication module attachment.
• Check the settings of "Communication Detail Settings".
• Review the contents of the message to transmit.